R and V Works FF6 Información técnica Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
Compressor Application Manual
32
19.4 - Incorrect compressor
installation / fixation
Check if the rubber grommets are too
tight. If so, loosen them, otherwise this
detracts from the vibration damping.
IV
Figure 25 - Rubber Dampers
Bolt
Nut
Rubber dampers
Washer
Sleeve
Compressor base
Cabinet base
INCORRECT CORRECT
19.5 - Compressor inadequate for
the system
Consult the Embraco Compressor
Application Table. Change the
compressor for the right model.
19.6 - Compressor with low capacity
This defect is not common. If you are
not absolutely sure whether this is the
defect, move on to the other possible
causes. If none apply, then change
the compressor.
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

Comentarios a estos manuales

Sin comentarios